[1]杨传雷,刘春罡,罗巩固,等.柴油机相继增压系统信号模拟器的开发[J].应用科技,2010,37(08):45-48.[doi:10.3969/j.issn.1009-671X.2010.08.011]
 YANG Chuan-lei,LIU Chun-gang,LUO Gong-gu,et al.Development of signal simulation generator for the sequentially turbocharged system of a diesel[J].Applied science and technology,2010,37(08):45-48.[doi:10.3969/j.issn.1009-671X.2010.08.011]
点击复制

柴油机相继增压系统信号模拟器的开发(/HTML)
分享到:

《应用科技》[ISSN:1009-671X/CN:23-1191/U]

卷:
第37卷
期数:
2010年08期
页码:
45-48
栏目:
动力与能源工程
出版日期:
2010-08-05

文章信息/Info

Title:
Development of signal simulation generator for the sequentially turbocharged system of a diesel
文章编号:
TK431.5
作者:
杨传雷1刘春罡1罗巩固2王银燕1
1.哈尔滨工程大学 动力与能源工程学院,黑龙江 哈尔滨 150001; 2.陕西柴油机厂 质量管理中心,陕西 兴平 713103
Author(s):
YANG Chuan-lei1 LIU Chun-gang1 LUO Gong-gu2 WANG Yin-yan1
1.College of Power and Energy Engineering, Harbin Engineering University, Harbin 150001, China; 2. Quality Management Center, Shaanxi Diesel Engine Factory, Xingping 713103, China
关键词:
柴油机相继增压系统信号模拟器
Keywords:
diesel sequentially turbocharged system signal simulation generator
分类号:
TK431.5
DOI:
10.3969/j.issn.1009-671X.2010.08.011
文献标志码:
A
摘要:
介绍了一种适用于开发相继增压控制仪的信号模拟器,详细描述了其主要功能以及软硬件设计方案.硬件设计主要以ATmega128单片机为核心部件,系统地集成了碟阀模拟模块、转速模拟模块和压力模拟模块等.软件主要包括数据采集程序、转速采集程序和自动控制程序等.试验结果表明,该模拟器较好地解决了相继增压控制仪在开发过程中的模拟信号输入问题.
Abstract:
A kind of signal simulation generator was introduced in this paper, which is suitable for the development of a the sequentially turbocharged control system of a diesel. Its basic function and software and hardware design were presented. It is mainly composed of ATmega128 single chip, and integrates the butterfly valve simulation module, speed simulation module and pressure simulation module, etc. The software includes data acquisition programme, rotating speed acquisition programme, automatic control programme, etc. The experimental results indicated that the signal simulation generator better solved the problem of simulation signal input during the development process of a diesel’s sequentially turbocharged control system.

参考文献/References:

[1]王贺春,聂志斌,刘丕人,等.采用相继增压技术改善柴油机低负荷性能的试验研究[J].哈尔滨工程大学学报, 2007,28( 8): 870-874.
[2]张秀萍,朱齐丹,蔡成涛.基于单片机和CAN总线的信号测量和数据传输[J].应用科技,2005,32(9): 25-27.
[3]南建辉,熊鸣,王军茹.MCS51单片机原理及应用实例[M]. 北京:清华大学出版社, 2003.
[4]饶运涛,邹继军,郑勇芸.现场总线CAN原理与应用技术\M]. 北京:北京航空航天大学出版社, 2003.
[5]马忠梅,籍顺心,张凯,等.单片机的C语言应用程序设计[M]. 北京:北京航空航天大学出版社, 2003.
[6]郭天祥.51单片机C语言教程[M].北京:电子工业出版社, 2009.

相似文献/References:

[1]孙俊.柴油机活塞温度场有限元分析的简单方法[J].应用科技,2009,36(06):69.[doi:doi:10.3969/j.issn.1009-671X.2009.06.017]
 SUN Jun.A simple method of finite element analysis for diesel piston temperature field[J].Applied science and technology,2009,36(08):69.[doi:doi:10.3969/j.issn.1009-671X.2009.06.017]
[2]张子英,张光炯,张保成,等.柴油机主副连杆有限元分析方法[J].应用科技,2010,37(11):5.[doi:10.3969/j.issn.1009-671X.2010.11.002]
 ZHANG Zi-ying,ZHANG Guang-jiong,ZHANG Bao-cheng,et al.Finite element analytic method of chiefvice connecting rods[J].Applied science and technology,2010,37(08):5.[doi:10.3969/j.issn.1009-671X.2010.11.002]
[3]黄建余,崔欣洁,杨传雷,等.柴油机相继增压防喘振控制器的开发[J].应用科技,2011,38(06):1.[doi:10.3969/j.issn.1009-671X.2011.06.001]
 HUANG Jianyu,CUI Xinjie,YANG Changlei,et al.Development of an anti- surge controller for diesel engine sequential turbocharging system[J].Applied science and technology,2011,38(08):1.[doi:10.3969/j.issn.1009-671X.2011.06.001]
[4]王伟才,王银燕,王贺春.相继增压柴油机进排气系统建模与增压器切换点计算分析[J].应用科技,2005,32(05):46.
[5]王伟才孙俊,王银燕,曾春荣.相继增压柴油机线性模型动态实时仿真[J].应用科技,2005,32(06):53.
[6]左大军,王银燕,杨传雷,等.柴油机相继增压控制系统硬件可靠性研究[J].应用科技,2014,41(04):65.
 ZUO Dajun,WANG Yinyan,YANG Chuanlei,et al.Investigation of hardware reliability of sequential turbocharging control system with diesel engine[J].Applied science and technology,2014,41(08):65.
[7]胡松,王银燕,孙永瑞,等.基于GT-power和Simulink的相继增压切出过程仿真研究[J].应用科技,2015,42(05):55.[doi:10.11991/yykj.201410007]
 HU Song,WANG Yinyan,SUN Yongrui,et al.Simulation of sequential turbochargingcutting out process based on GT-power and Simulink[J].Applied science and technology,2015,42(08):55.[doi:10.11991/yykj.201410007]
[8]袁帅,王贺春,林娉羽,等.两种米勒循环方案对发动机性能影响对比[J].应用科技,2017,44(05):17.[doi:10.11991/yykj.201612020]
 YUAN Shuai,WANG Hechun,LIN Pinyu,et al.Contrast on the effects of two miller cycle schemes on engine performance[J].Applied science and technology,2017,44(08):17.[doi:10.11991/yykj.201612020]
[9]杨传雷,马传杰,王银燕,等.相继增压柴油机调速控制算法研究[J].应用科技,2017,44(05):30.[doi:10.11991/yykj.201607019]
 YANG Chuanlei,MA Chuanjie,WANG Yinyan,et al.Research on the speed regulation control algorithms for sequential turbocharging diesel engine[J].Applied science and technology,2017,44(08):30.[doi:10.11991/yykj.201607019]
[10]袁帅,王贺春,李禹函,等.EGR技术对柴油机性能的影响[J].应用科技,2018,45(03):81.[doi:10.11991/yykj.201703001]
 YUAN Shuai,WANG Hechun,LI Yuhan,et al.Influence of EGR technology on the performances of diesel engine[J].Applied science and technology,2018,45(08):81.[doi:10.11991/yykj.201703001]

备注/Memo

备注/Memo:
作者简介:杨传雷(1978-),男,博士研究生, 主要研究方向:内燃机测试技术,E-mail:yangchuanlei@hrbeu.edu.cn.
更新日期/Last Update: 2010-09-02