[1]卢霞,匡波,孔浩铮,等.SBLOCA整体试验台架的比例模化分析与初步评估[J].应用科技,2019,46(05):80-87.[doi:10.11991/yykj.201812002]
 LU Xia,KUANG Bo,KONG Haozheng,et al.Scaling analysis and preliminary evaluation of integral effect test facility for SBLOCA[J].Applied science and technology,2019,46(05):80-87.[doi:10.11991/yykj.201812002]
点击复制

SBLOCA整体试验台架的比例模化分析与初步评估(/HTML)
分享到:

《应用科技》[ISSN:1009-671X/CN:23-1191/U]

卷:
第46卷
期数:
2019年05期
页码:
80-87
栏目:
核科学技术与应用
出版日期:
2019-09-05

文章信息/Info

Title:
Scaling analysis and preliminary evaluation of integral effect test facility for SBLOCA
作者:
卢霞 匡波 孔浩铮 刘鹏飞
上海交通大学 机械与动力工程学院, 上海 200240
Author(s):
LU Xia KUANG Bo KONG Haozheng LIU Pengfei
School of Mechanical Engineering, Shanghai Jiao Tong University, Shanghai 200240, China
关键词:
大型非能动先进压水堆小破口失水事故现象过程识别与排序表分级双向比例模化整体试验台架先进堆芯冷却机理实验比例模化分析Relap5程序计算
Keywords:
large passive advanced pressurized water reactorSBLOCAPIRTH2TSintegral effect test facilityACMEscaling analysisRELAP5 program calculation
分类号:
TL364.4
DOI:
10.11991/yykj.201812002
文献标志码:
A
摘要:
为了对大型非能动先进压水堆安全设计以及相关事故分析程序的适宜性进行验证评估,针对非能动压水堆核电厂AP1000重要的设计基准事故之一——小破口失水事故(SBLOCA),基于其SBLOCA的现象过程识别与排序表(PIRT)中高重要度现象过程,采用系统性的分级双向比例模化(H2TS)方法,评估大型非能动先进堆芯冷却机理试验(ACME)台架模化验证AP1000核电厂SBLOCA事故的适宜性,进一步地,采用系统分析程序对AP1000小LOCA事故的模拟与部分ACME小破口事故验证试验的结果进行对比,从而初步评估了ACME对于AP1000小LOCA验证模拟的适宜性。
Abstract:
In order to verify the suitability of safety design of large passive advanced pressurized water reactor (PWR) and the reliability of related accident analysis program, the suitability of modeling the AP1000 under small break loss of coolant accident (SBLOCA) through the Advanced Core-cooling Mechanism Experiment (ACME) is evaluated in this paper. The process of SBLOCA with medium and high importance in the phenomena identification and ranking table (PIRT) is verified by means of hierarchical two-tiered scaling (H2TS). In addition, the system analysis program RELAP5 is used to scale the SBLOCA process of the AP1000. The scaling results are compared with ACME test results, to evaluate the suitability of using ACME to scale the SBLOCA of AP1000.

参考文献/References:

[1] Westinghouse Electric Company LLC. AP1000 PIRT and scaling assessment[R]. 15230-0355. Pittsburgh, PA, 2001.
[2] ZUBER N. Appendix D:hierarchical, two-tiered scaling analysis, an integrated structure and scaling methodology for severe accident technical issue resolution. NUREG/CR-5809[R]. Washington:U.S Nuclear Regulatory Commission, 1991.
[3] ISHⅡ M, KATAOKA I. Scaling laws for thermal-hydraulic system under single phase and two-phase natural circulation[J]. Nuclear engineering and design, 1984, 81(3):411-425.
[4] TAITEL Y, DUKLER A E. A model for predicting flow regime transitions in horizontal and near horizontal gas-liquid flow[J]. AIChE journal, 1976, 22(1):47-55.
[5] SEEGER W, REIMANN J, MÜLLER U. Two-phase flow in a T-Junction with a horizontal inlet. Part I:phase separation[J]. International journal of multiphase flow, 1986, 12(4):575-585.
[6] ZUBER N. Problems in modeling of small break LOCA[C]//Heat Transfer in Nuclear Reactor Safety. New York:Hemisphere Publishing, 1982.
[7] ZHU Sheng. Test analysis of CAP14005cm break accident based on the acme test facility[C]//Proceedings of the 201624th International Conference on Nuclear Engineering. USA, North Carolina, Charlotte, 2016.
[8] 李玉全, 常华健, 叶子申, 等. ACME整体试验台架堆芯模拟体设计[J]. 动力工程学报, 2016, 36(3):236-241
[9] 汪映荣. CAP1400核电技术特点和工程进展[J]. 中国核电, 2018, 11(1):35-40
[10] 邓程程, 常华健, 秦本科, 等. 非能动试验台架中CMT的比例分析及失真评价[J]. 原子能科学技术, 2013, 47(11):2026-2032
[11] SCDAP/RELAP5 Development Team. SCDAP/RELAP5/MOD 3.2 code manual[R]. Washington:Idaho National Engineering Laboratory, 1998.
[12] 朱升. ACME台架程序建模及试验初始条件确定方法研究[J]. 原子能科学技术, 2016, 50(7):1179-1185

相似文献/References:

[1]张国强.船用核动力装置高压安注系统可靠性分析[J].应用科技,2005,32(05):49.

备注/Memo

备注/Memo:
收稿日期:2018-12-04。
作者简介:卢霞,女,硕士研究生;匡波,男,副教授,博士
通讯作者:匡波,E-mail:bkuang@sjtu.edu.cn
更新日期/Last Update: 2019-08-29